SETUP VMNET2 VMWARE FUSION 11 MAC FOR MAC OS X
SETUP VMNET2 VMWARE FUSION 11 MAC MAC OS X
SETUP VMNET2 VMWARE FUSION 11 MAC MAC OS

Sudo '/Library/Application Support/VMware Fusion/vmnet-bridge' -D vmnet0 '' Entering event loop. You can do this either by shutting down VMware completely (turn off your guest operating systems, and quit the VMware Fusion application), or you can run the following commands as an administrator in Terminal, which will stop any bridge currently running (or do nothing if no bridge is running) and then restart it, providing the output as shown: sudo killall vmnet-bridge However, if you do encounter the above error anyway, you need to restart the VMware network bridge. If you check System Preferences now, you should see a that AirPort has a yellow dot next to it and reads as having a “Self-Assigned IP Address.” Now that you have a physical link on your AirPort card, you should be able to start the VMware Fusion virtual machine with bridged networking mode without incident. Just go to your AirPort menu bar item and select “Create Networkâ€¦” and create the network (preferably encrypted). The easiest way to do this is to set up a Computer-to-Computer network using AirPort. Obviously, if you have no other devices to connect to, you need to fake one. VMware Fusion will give you no errors or warnings that a bridge is unavailable until you try to connect your virtual machine’s network while set to bridge, in which case VMware Fusion will complain with an error that reads: “The device on /dev/vmnet0 is not running.”

SETUP VMNET2 VMWARE FUSION 11 MAC MAC OS

In other words, Mac OS X’s Network System Preferences pane must show you a yellow dot next to at least one physical networking device (probably either your “Built-in Ethernet” or your “AirPort” ports). Finally, I can connect to Vodafone’s 3G network, and all should be well.įirst, in order for VMware to actually initiate the network bridge when it starts up, it must detect that a physical link is active on your Mac. At this point, I can enable Windows XP’s built-in Internet Connection Sharing (stupidly dubbed “ICS” because everything needs a TLA) on the 3G connection so that Windows NATs it through to the bridged virtual ethernet card.

SETUP VMNET2 VMWARE FUSION 11 MAC MAC OS X

Once bridged, both the Windows guest and the Mac OS X host would logically be on the same ethernet network segment. To get the Windows guest to share its Internet connection from the 3G card to my Mac, I would need to bridge VMware’s virtual ethernet adapter from the Windows guest to the Mac OS X host. The solution is obvious, but a few gotchas really bit me hard. I wanted my Mac to be directly connected. Connecting to the Internet with the 3G card using the Windows guest was smooth sailing, but that only provided the Internet connection to the Windows virtual machine. The only way I could get my Vodafone 3G card to work was to fire up a Windows XP guest inside of my MacBook Pro, using VMware Fusion. Of course, Vodafone’s software for Windows works without a hitch.

SETUP VMNET2 VMWARE FUSION 11 MAC FOR MAC OS X

Unfortunately, the Vodafone Mobile Connect software for Mac OS X as of this writing is obscenely poor. In my situation, I have temporarily obtained a Vodafone 3G mobile card. In some situations, like the odd one I now find myself in, the only way to get Internet connectivity is to use a solution that requires a fair bit of maneuvering.

Setup vmnet2 vmware fusion 11 mac